What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 08:24

so, what happens?
2024–10–16 [ OO OLAOYE OYEBODE ]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
How do people develop stage 4 cancer without noticing until it’s too late?
First Sentence:
Can the fuse protect the electronic devices from lightning instead of a surge protector.
The bolt then partially travels down the line to your home.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
But it can get overloaded, and no longer works.
a photo is worth a thousand words.
One is “what exactly is in a ‘surge protector’ ? ”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is 'the assistant's answer'
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
How do you find out who your handler is as a targeted individual?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
but this device (an Inductor) … impedes the rapid changes in the current.
Should India conduct another air strike to attack Pakistan over the Pahalgam attack?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
There are three different concepts here that are getting confused.
The other is “what does a “fuse” do?”
The third is lightning and “how it gets conducted into a home.”
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
A fuse is a non-resetable over current circuit protector.
Just sitting at home with this huge cock. Who can take care of it for me?
Barnstars:
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
I post the exact comment here.
New species of dinosaur discovered that 'rewrites' T.rex family tree - BBC
This device then solves the entire problem.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Because the load is inductive, the current lags the voltage.(by a bit).
For this case there are devices called Metal oxide varistors (MOV).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Why do men like BBW? What is the attraction?
This is where the MOV conducts again, and dissipated the energy.
2024–10–14 [Omar Gharbi Omar Gharbi ]
A circuit breaker is similar, but is resettable.
If there exists a “New York of Australia”, is it Sydney or Melbourne?
[old diagram got deleted by accident]
An AC voltage/ current source, and an ac inductive load.
What does a fuse do?
Edit 2024–10.
Here is a simplified AC power diagram.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
So, the voltage could go up to 500 volts, and the fuse will not open up.
In schematic diagrams this is the symbol for a fuse:
Now when you have a certain ac resistance, then a current flows in a loop.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
eight
(Dc diagram shown, AC is similar).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
It also is a device that limits the change in current flow.
There are two important concepts here.
2024–10–10[John johnson John Johnson ]
Upvotes:
These devices are installed between the “hot” and “neutral” and protective ground.
what exactly is a ‘surge’ protector?
These are simplified answers to the original question, and does not change anything I wrote above.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
He then describes the function of a fuse.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
but I think this circuit , shows a few more pieces.
He then asserts :
He then describes Rainy Season and Lightning.
At one ohm, the resistor has a maximum of 1 watt power.
But… the neutral is now “floating” because of the 1 ohm resistance.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
What is lightning?
the problem then depends on "how fast does the fuse operate?".
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This one hit behind the barn.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The MOV will conduct when the voltage exceeds 50% of line voltage.
One
nine
This is where this question deviates from being a 'generic' question, and becomes more specific.
It seems Mohan does not understand the difference between a comment and an Answer.
At least they know the answer if they wanted it.
[image of Common-mode choke]